2000 SSEI will not crank
#1
2000 SSEI will not crank
Just picked up the car and it seems that it will intermittently go into a no start mode. Starter is not receiving a signal from the ignition switch. If i jump the signal wire and put 12v to the starter car will start and run fine. I also noticed that the light on the dash which indicates gear selected has also gone out, not sure if it is related. Going to get a wiring schematic to see if i can trace the ignition wire. Any thoughts?????
#2
Senior Member
True Car Nut
theres a PNP(park nuetral position switch) on the trans that likes to go out sometimes if you got a diagram i would start there and if you have the proper signals
#4
DINOSAURUS BOOSTUS
Expert Gearhead
This reminds me of something a buddy ran into. Here'* a link to the thread wtih the problem and solution
http://www.bonnevillepro.com/forums/...0095&hilit=pcm
http://www.bonnevillepro.com/forums/...0095&hilit=pcm
#5
On the way to work this morning, actually in the tim hortons drive through the indicator light came back on. Now it starts fine.
Thinking JW is on the right track. I'll start there.
Thanks Guys.
#6
Senior Member
True Car Nut
actually according to bills link the switch is internal to the trans on 2000+ bonnies, so if yours is bad i think hes suggesting you can change it over to a external one like on most others. other wise i guess the trans would have to come out to replace it. doesnt seem like one of gm'* better ideas.
#7
DINOSAURUS BOOSTUS
Expert Gearhead
I was merely adding onto what you tossed out JW. I thought the same thing. Yes the 00+ Bonne is internal and you "can" swap it by lowering the drivetrain to get the side cover off. I however would put an external switch on because that can take under an hour and the side cover is going to take 3-6 hours.
#8
Thanks Bill, after reading the post i think that is exactly what i'm going to do. Off to the scrap yard Saturday morning to see what i can find. Thanks for the help. Will post the results when i'm finished.
Thanks for the help!
Thanks for the help!
#9
DINOSAURUS BOOSTUS
Expert Gearhead
Center is a 15mm, bolts that hold it to the case are 13mm. ..Keep in mind that you must align that dot that'* mentioned and pointed at in the pictures.
Thread
Thread Starter
Forum
Replies
Last Post
repinS
General GM Chat
12
11-26-2004 10:35 AM