Harmonic balancer install??
#1
Senior Member
Posts like a Turbo
Thread Starter
Harmonic balancer install??
Just found that my crank sensor on my 1993 SE was bad causing intermittent stalling issues. Got the harmonic balancer off and getting ready to replace the crank sensor . When I put the balancer back on how should I go about it? FSM says buy a new bolt and torque it to 110 ft pds then crank it 76 degrees more. The used bolt has already been stretched once so how would I reinstall it?
#5
Retired
Me too. Let the impact fly!!!!
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#6
Senior Member
Posts like a Turbo
Thread Starter
Thanks everyone! I don't have an impact. I will be using the big guns. Does 120 foot pounds sound about right?? I assume I should put a liitle motor oil on the crankshaft?? Maybe a little Loctite on the threads ??
#7
Retired
Anti-seize on the bolt and the balancer itself. Makes it easier to remove the next time.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Thread
Thread Starter
Forum
Replies
Last Post