99 SSEI EGR EVAP P1404 Problems
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Dec 2004
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
99 SSEI EGR EVAP P1404 Problems
I really need some expert help on this for I am chasing a ghost in the machine (99 SSEI). Let me start off by stating what I have done. New plugs, wires, catalytic converter, techron fuel treatment, and a used EGR valve (that I tested with a 9V battery). I can’t remember the original codes I was getting but it was for a bad catalytic converter (and it was bad) and for the evap system. Then all of a sudden I started getting P1404. I took the EGR valve off and the pintle was clogged with carbon so I replaced it with a used one I had. Now the only code I get is the P1404 and that code fluctuates between setting off the CEL, pending, and not at all. I have multiple times done the pintle reset procedure on the EGR valve but my problem is still there. This is what the car is doing, at first acceleration and at slow speeds around 40mph while in OD when I am just barely giving gas the car is sputtering and the vacuum boost fluctuates about 5 pounds. Sometimes when I am at idle and in park if I step on the brake and the boost will fluctuate the slightest bit as well. And I have always had trouble with back pressure on my fuel tank while filling up at certain stations. Basically the fuel pump would click off every $5-10. I am at the point where I am thinking about replacing the fuel pump, fuel limiter vent valve, and flashing the computer. Any help would be greatly appreciated.
Jack
Jack
#4
Senior Member
True Car Nut
When you say the boost pressure fluctuates do you mean at WOT or idle. If at WOT you could have a problem with the BCA or BCS. If at idle, you have an intermittent vacuum leak that I suspect may involve the EGR and/or EGR tube.
#5
Member
Posts like a V-Tak
Thread Starter
Join Date: Dec 2004
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
The EGR valve turned out to be the problem. The pintle moved free and clear and when I hooked it up to a 9 volt it clicked. Either way I swapped the EGR and she runs great.
Thread
Thread Starter
Forum
Replies
Last Post