Well, my RX-4750 came and....well, I finally used that intake pipe that has been in my trunk for a few months. 4 cuts with a hack saw, several minutes with a soldering iron (IAT hole), and a bit of pushing and shoving later, we have our selves a short ram.

(don't mind the fact that the IAT isn't plugged in...it was by the time I started it up...







First impressions:
1) Sounds sweet at cold idle.
2) I friggen hate it. Why? The roads are really icy and I have an even harder time getting traction while accelerating....isn't torque grand

In all seriousness though, it feels torquier, better throttle response, and I can't wait for dry roads.

Looks great....nice, clean,install.

WTG Logan...

Not sure how you held it down..or supported it..but the metal they give you will snap for the bracket...

I used a piece of extra long vacuum hose for flexing.

Thank you, thank you very much.

Yeah, I even got that IAT on the right side...now if only it will stay in its hole I'll be all set

Got pics? I don't quite understand.

As of right now there is not additional support...bad?

you now need a heatshield

I'll PM you my addy...lemme know when you finish it

and ill take your paypal address

Chrome looks great sir.

Nice.

Go to you nearest hardware store and drop about 10 bucks on some reflectex and a roll of reflectex tape. Thatss what mine is made of.



I recently closed the top in and am within 5* of ambient temps