New Magnaflow tips
Thread Starter
Member
Posts like a V-Tak
Joined: Aug 2006
Posts: 37
Likes: 0
From: Carlisle PA
New Magnaflow tips
I guess you could call it my Christmas present to me. New Magnaflow tips, (3516
Got them from Cardomain.com for about $52 a piece. A local muffler shop to install for $25.
The new tips are on an angle but I can live with that. At least there is more shine than the old cowbells!
Old look:
New look:
Tips:
Got them from Cardomain.com for about $52 a piece. A local muffler shop to install for $25.
The new tips are on an angle but I can live with that. At least there is more shine than the old cowbells!
Old look:
New look:
Tips:
Senior Member
True Car Nut
Joined: Jul 2004
Posts: 7,545
Likes: 1
From: Twin Falls, Idaho
Originally Posted by Sinister
Cost that much to weld them on? 
A local shop would probably do that for me for $5 a tip... looks nice though 
A local shop would probably do that for me for $5 a tip... looks nice though Nationally midas charges $40 for each tip
Senior Member
Posts like a Turbo
Joined: Dec 2006
Posts: 430
Likes: 0
From: Pittsburgh PA
Originally Posted by Hans
Originally Posted by Sinister
Cost that much to weld them on? A local shop would probably do that for me for $5 a tip... looks nice though
A local shop would probably do that for me for $5 a tip... looks nice though Nationally midas charges $40 for each tip
Then again this place also does cat-back exhausts, minus mufflers, for ~$100 for 2.5", and 120 for 3" or so.
Senior Member
Posts like a Northstar
Joined: Jul 2006
Posts: 508
Likes: 0
From: Meridian, ID
Looks good. I like mine up higher in the cutout myself. Mine were low and uneven too when I got it back and I got the jack and a 4x4 out and got them bent to where I like them better.
Senior Member
Posts like a Camaro
Joined: Apr 2005
Posts: 1,121
Likes: 0
From: Niagara Falls Ontario Canada
Love that look! They look great! Same style as mine. I would have tucked them in a bit, but I know what you went through, my shop had to cut off a bit of pipe and custom bend to get the right depth and straightness in them.