Executive Hauler clips
Thread Starter
Senior Member
Certified GM nut
Joined: May 2005
Posts: 2,155
Likes: 0
From: Wickliffe, Ohio

Start up - idle to light 2k rev it was midnight so I didn't want to make to much noise since most of my neighbors go to bed early since they're old.
http://media.putfile.com/98-SSEi-Start-up
From a roll, please ignore the middle of the road driving
http://media.putfile.com/Roll-20
0-100
I had to move a 1/4 mile down the road after I almost killed a few raccoons on the first attempt.
http://media.putfile.com/0-100-98-SSEi
http://www.youtube.com/watch?v=G3ojeFMJmLM YouTube link
Temp was about 58 Degrees & humidity about 40%
Mods are same as sig below.
Let me know what you think
Ed
http://media.putfile.com/98-SSEi-Start-up
From a roll, please ignore the middle of the road driving
http://media.putfile.com/Roll-20
0-100
I had to move a 1/4 mile down the road after I almost killed a few raccoons on the first attempt.http://media.putfile.com/0-100-98-SSEi
http://www.youtube.com/watch?v=G3ojeFMJmLM YouTube link
Temp was about 58 Degrees & humidity about 40%
Mods are same as sig below.
Let me know what you think
Ed
Thread Starter
Senior Member
Certified GM nut
Joined: May 2005
Posts: 2,155
Likes: 0
From: Wickliffe, Ohio

Originally Posted by bonnie94ssei
I'd let you know, but I can't view anything that people post on Putfile. :(
Thread Starter
Senior Member
Certified GM nut
Joined: May 2005
Posts: 2,155
Likes: 0
From: Wickliffe, Ohio

I've got a bad spot on my flywheel, sometimes it doesn't start on the first crank. So I went to start it earlier in the day and it cranked enough just to let a out a little sputter but then didn't start. That threw the light
Thread Starter
Senior Member
Certified GM nut
Joined: May 2005
Posts: 2,155
Likes: 0
From: Wickliffe, Ohio

I should clarify bad spot meaning a few bad teeth, it'* not 180 degrees off or missing a large chunk.
I'm still waiting on my video to finish "processing" on YouTube. :?
I'm still waiting on my video to finish "processing" on YouTube. :?
Thread
Thread Starter
Forum
Replies
Last Post



