MAP 5volt signal test
Thread Starter
Retired Senior Admin
Expert Gearhead
Joined: May 2006
Posts: 29,661
Likes: 43
From: Sheboygan Wisconsin
MAP 5volt signal test
Locate your MAP sensor(*), they are on the rear of the engine above the rear valve cover. The plug(*) are on the rear and point down.
Lift on the tab, wiggle and push down. Do not pull on the wires.
Use your multimeter and place the red probe on the gray wire, and the black probe on the black wire. With the key in the run position but not with engine running, you should get a 5 volt reading
Lift on the tab, wiggle and push down. Do not pull on the wires.
Use your multimeter and place the red probe on the gray wire, and the black probe on the black wire. With the key in the run position but not with engine running, you should get a 5 volt reading
Thread
Thread Starter
Forum
Replies
Last Post
