For those of whom have had their SuperCharger Cover removed by a friend or just didnt pay attention to detail when removing it... heres some helpful information

1) L67 w/ Cover ON


2) L67 w/ Cover OFF


3) Hole by thumb and Protruding Piece on the bracked go together


4) Pieces put together


5) For easier installation hold to 45* angle when putting pieces in Pic 3 & 4 together


6) If you run your wires over the cover like I do vs under the snout DO NOT forget to slide them back on top lol


7) The cover will hit this plastic vacuum relay, box, part, thingy


Flexing the sides of the cover together (inward) will allow the cover to slide past it, dont worry, the plastic is very pliable so feel free to move it and flex it to get it to fit flush


9) Finished piece laying flat


If you have any problems for further questions feel free to PM me
good luck
- TL