ROLLER ROCKERS AND STAINLESS VALVES FOR SERIES 1
Senior Member
Posts like a Camaro
Joined: Jan 2002
Posts: 971
Likes: 1
From: Simi Valley, CA
The way to see if a rocker will fit is just to measure it and fit one on. Just use small block Chevy rockers will most likely work. And valves are valves..... they dont fit specific heads they are just valves. So if your intake is 1.8" big, just get one 1.8" big with the specific length to fit in the head.
Senior Member
Posts like a Camaro
Joined: Jan 2002
Posts: 971
Likes: 1
From: Simi Valley, CA
Off the top of my head no. I would have to take one of the valves off the desk and measure it, I will do it next time I am next to them and when I remember. :P But 1.94 I believe will be too big maybe, that'* like 8-9% larger than stock and I don't believe if will fit because it will overlap into the exhaust valve side and vice versa.
Guest
Posts: n/a
i have put 1.94 valves in a 305 chev head that had 1.72 valves in it. 
i did that with a set of 84 trans am 305 HO heads.
what was great, i put them on a 355 i build, and best of all
58CC chambers
took me to almost 11.5:1 compression
with flat tops
i did that with a set of 84 trans am 305 HO heads.
what was great, i put them on a 355 i build, and best of all
58CC chambers
took me to almost 11.5:1 compression
with flat tops
Senior Member
Posts like a Camaro
Joined: Jan 2002
Posts: 971
Likes: 1
From: Simi Valley, CA
Originally Posted by jeffrey10x2
i have put 1.94 valves in a 305 chev head that had 1.72 valves in it.
i did that with a set of 84 trans am 305 HO heads.
what was great, i put them on a 355 i build, and best of all
58CC chambers
took me to almost 11.5:1 compression with flat tops
i did that with a set of 84 trans am 305 HO heads.
what was great, i put them on a 355 i build, and best of all
58CC chambers
took me to almost 11.5:1 compression
with flat topsGuest
Posts: n/a
i built a 355 for my old drag car. i used the 305HO heads because they were 58cc.
i turned a best of 10.23 sec 1/4 mile time on slicks. but................. my ex told me to get rid of it
. i had a 468 that i was building for it, JE pistons, BME alum rods, steel crank , and rect. port alum heads too.
but hind sight is 20/20
should have kept the car and kicked her to the curb then
god i miss that car
i turned a best of 10.23 sec 1/4 mile time on slicks. but................. my ex told me to get rid of it
. i had a 468 that i was building for it, JE pistons, BME alum rods, steel crank , and rect. port alum heads too. but hind sight is 20/20
should have kept the car and kicked her to the curb then
god i miss that car
