pipe insulation
Thread Starter
Senior Member
True Car Nut
Joined: Jan 2003
Posts: 3,734
Likes: 0
From: Bloomington-Normal, IL 1997 SE
Originally Posted by Twister97
Can do! 
I hear that foam heat resistant stuff calling my name in isle 4! "Over hereereeeeee...."
I hear that foam heat resistant stuff calling my name in isle 4! "Over hereereeeeee...."
BonneMeMN, Twister and I will have to adapt whatever you do anyway to fit around our stupid PCM box.
Senior Member
True Car Nut
Joined: Jun 2002
Posts: 3,266
Likes: 1
From: Bedroom, Ontario
Originally Posted by macho_mike21
my wires are too short to reach any farther than where it is now. With the insulation I could be able to keep the IAT where it is now. If I have some leftover I might wrap the crossover pipe to shield the TB. I went to Lowes today but I might have been in the wrong spot in the store because I couldnt find it.
Senior Member
True Car Nut
Joined: Jun 2002
Posts: 3,266
Likes: 1
From: Bedroom, Ontario
Originally Posted by Twister97
You think Macho could also just splice them into new wires, using a connector? Maybe some 16 or 18 gauge wire?
Thread Starter
Senior Member
True Car Nut
Joined: Jan 2003
Posts: 3,734
Likes: 0
From: Bloomington-Normal, IL 1997 SE
Originally Posted by Drifter420
Yea.. can do that too.. but connectors usually reduces power and may change the ohms/resistance reading slightly.. thats why I would suggest straight solder instead..( since I believe that the IAT sends info back in ohmage or resistance?? ) but for IAT I don't know how that would affect it.
