Lazy Boy Throttle Body Cleaning
Thread Starter
Senior Member
Posts like a 4 Banger
Joined: Dec 2004
Posts: 113
Likes: 0
From: Rochester, NY
Lazy Boy Throttle Body Cleaning
Greetings!
I realize that the best way to clean my '93 L27s TB is to remove it, but can I use a throttle body cleaner spray to do a half-a$$ decent job while it'* still attached?...I was going to run the engine up to normal temp, then remove the MAF [after shutting the engine down] and spray the $hit out of the TB, re-install the MAF, then start her up to blow out the crap......I would repeat this until I ran out of spray or didn't notice anything disgusting coming out of the exhaust....My question is: since this procedure would involve many removal/replacements of the MAF & starting/stopping of the engine, is it possible to run the engine with the MAF out of the TB so that I could rev it while spraying?.....If not, is it feasable to leave the MAF in, and to carefully spray without hitting the MAF?.....BTW, after I put in my new CAI, I was able to remove the MAF screen, so that'* not an issue...Has anyone done this?...
Thanx,
Andy
I realize that the best way to clean my '93 L27s TB is to remove it, but can I use a throttle body cleaner spray to do a half-a$$ decent job while it'* still attached?...I was going to run the engine up to normal temp, then remove the MAF [after shutting the engine down] and spray the $hit out of the TB, re-install the MAF, then start her up to blow out the crap......I would repeat this until I ran out of spray or didn't notice anything disgusting coming out of the exhaust....My question is: since this procedure would involve many removal/replacements of the MAF & starting/stopping of the engine, is it possible to run the engine with the MAF out of the TB so that I could rev it while spraying?.....If not, is it feasable to leave the MAF in, and to carefully spray without hitting the MAF?.....BTW, after I put in my new CAI, I was able to remove the MAF screen, so that'* not an issue...Has anyone done this?...
Thanx,
Andy
Senior Member
True Car Nut
Joined: Jun 2003
Posts: 6,313
Likes: 2
From: Purgatory
I advise against doing that.
Its only $6 for a tb gasket, you get a better cleaning, you dont run the risk of fowling your plugs or O2 sensor.
Start stop start stop is hard on any engine, break out the ratchet and elbow grease
Its only $6 for a tb gasket, you get a better cleaning, you dont run the risk of fowling your plugs or O2 sensor.
Start stop start stop is hard on any engine, break out the ratchet and elbow grease
Thread Starter
Senior Member
Posts like a 4 Banger
Joined: Dec 2004
Posts: 113
Likes: 0
From: Rochester, NY
I'm going to replace the plugs/ O2 sensor/ oil after I do this anyway...I'm just wondering if the engine will run/rev with the MAF out of the TB...Or, if not, if it'* feasable to leave the MAF in and spray carefully without hitting it..
Senior Member
Posts like a Corvette
Joined: Sep 2003
Posts: 1,369
Likes: 1
From: springfield il
No it isnt. Why would you want to risk ruining an expensive sensor when you can take off the tb in only a few minutes and get it clean. If you do it the lazy way, itll never turn out right.
Senior Member
Certified Car Nut
Joined: Oct 2003
Posts: 19,756
Likes: 1
Originally Posted by jachin
No it isnt. Why would you want to risk ruining an expensive sensor when you can take off the tb in only a few minutes and get it clean. If you do it the lazy way, itll never turn out right.
Senior Member
Certified Car Nut
Joined: Mar 2003
Posts: 12,433
Likes: 2
I took the TB of a 93 L27 Saturday. It was a breeze, but appearently it had been off before. That brace dealy was there and mounted to the TB, but not to the studs below. I'm not sure why someone even put it back on if they were not going to mount it properly.
Guest
Posts: n/a
If you leave the throttle body in place and clean it, Use a good cleaner, such as Valvoline, or STP throttle body and intake cleaner... Plate coating, sensor and Cat converter safe...
The MAF can be removed, the car will idle without it, not great but it should... You should be able to open the throttle a bit too.... It may stall out on you tho...
I would reccomend a new gasket ans removal of the Throttle Body for cleaning... You'd be supprised at whats on the back of the TB.... Mine looked horrid.... And I had done several of the cheap cleanings...lol...
Good Luck
I think I have posted these too many times... LMAO
After Cleaning
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
The MAF can be removed, the car will idle without it, not great but it should... You should be able to open the throttle a bit too.... It may stall out on you tho...
I would reccomend a new gasket ans removal of the Throttle Body for cleaning... You'd be supprised at whats on the back of the TB.... Mine looked horrid.... And I had done several of the cheap cleanings...lol...
Good Luck
I think I have posted these too many times... LMAO
After Cleaning
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Guest
Posts: n/a
You should replace the gasket...
I reused mine... It was still in good shape and was not crushed.... I haven't lteked a drop...
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
I reused mine... It was still in good shape and was not crushed.... I haven't lteked a drop...
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
