Thanks! 150$ aint bad.

Ummm...so that'* $399 for the rockers and $150 for the labor to install??

About $550 for new rockers?? Yikes.... :?

my bad on the supercharger question, i thought only SSEi'* and newer SSE'* had superchargers...as for the rockers and cams and such, that'* a lot of money..after i do the exhaust and all that good stuff, other than air intake..is there anything cheap, like $125 and lower or in that range that I can do that would be worth it?


HARGZ

Pay to play baby..you might find them used on clubgp.com. You can also get 1st gen rockers which are a lot cheaper. Maybe 299 new or 200 used...

Correct me if I'm wrong here, but don't higher ratio rockers from a 350 work, as well as being a dime a dozen?

I don't know for sure but I highly doubt it.

It just seems strange. I was looking into some 1.7 roller rockers for my 351 Cleveland, a rare engine with hard to find parts, and 16 of them weren't even that much.

TMoney, if you do change the rockers, make sure you re-measure your lifter to rocker pushrod length just to be on the safe side.

dont you need new rods and springs to go with the rockers? your looking close to 1000$ by then. what are those 300$ rockers you were talking about? can you show me some

http://www.intense-racing.com/Mercha...egory_Code=HCV

Don't forget a 180 T-stat if you haven't got it. no performance.. but protection