Fuel Pump
Thread Starter
Senior Member
True Car Nut
Joined: May 2003
Posts: 8,135
Likes: 1
From: Lethbridge, Alberta, _______Canada._______ West Coast Bonneville Fest ___05,06,07 Survivor___
Fuel Pump
I purchased a Fuel pump from TRE Performance quite some time ago.
I have it here now, and was curious about it...the two pin connector it comes with has bare wire ends at the end of about 6 inches of wire.
If I have to splice and solder these wires...is there any special precautions/solder/or shrink tube I should use for being inside my fuel tank?
BTW this is a 255 LPH unit.
It does not have the nipple on the top of it, were as most Warlbro units do, this is the one that the small 1/8" line attches to and hangs down into the tank.
I have it here now, and was curious about it...the two pin connector it comes with has bare wire ends at the end of about 6 inches of wire.
If I have to splice and solder these wires...is there any special precautions/solder/or shrink tube I should use for being inside my fuel tank?
BTW this is a 255 LPH unit.
It does not have the nipple on the top of it, were as most Warlbro units do, this is the one that the small 1/8" line attches to and hangs down into the tank.
Thread
Thread Starter
Forum
Replies
Last Post
mikeblue94
1992-1999
8
Oct 31, 2004 03:20 PM
