ecu pinout diagram
#3
Retired
Not sure if these will help, but they are for my 2000 Blazer 4.3L.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#5
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Mar 2012
Location: Las Vegas
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
I check every single pin and all pins were in the same place as the chart u send me any more ideas of what could this be why I am still not getting a 5 volt reference to the tps sensor ?
#6
Retired
Ok, hmmm. Which connector/pin are you testing for the 5V?
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#9
Junior Member
Posts like a V-Tak
Thread Starter
Join Date: Mar 2012
Location: Las Vegas
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
I am testing them with the neg of the multimeter on battery neg and the positive of the multimeter to the gray cable that comes out of e pcm
#10
Retired
Don't backprobe either of those pins. Remove the entire C3-CLEAR connector and test those 2 pins again.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel