Fabbed up these Pods over the week end using some I bought from AutoZone and welded them to the existing pillar plastic cover. little duplicolor vinyl grey and presto....

Thats a great looking pod, you can hardly tell its hand made, well done

Wow... nice pod

It blends in seamlessly. Good job. I eventually would like to get pods like that.

that is an awesome idea. good job.

Looks real nice but uhh...anyone else notice the Fuel gauge is designed for a carb engine or am I just tired?

Yeah, that'* definetly a SWEET pillar pod setup. I was planning on something like that in the future.

But i'm with Doc, what'* up with the carb gauge? You need more PSI then that...

Nitros!!!

what system are you using? how hard was it to install? Have you discussed this before in another post?

Have you done the 1/4 with the nitros yet? what about impact to the system? and when do you push the button? first, second, third or fourht gear???

dont injectors run at like 45-50 PSI?

put a boost gauge in there instead

air/fuel or egt....