O2 Sensor Code
#1
Senior Member
Posts like a Northstar
Thread Starter
O2 Sensor Code
Did a routine maint. on my '91 Olds Regency Elite. Replaced plugs, wires, filters etc.... Also replaced the O2 sensor, and because it had been idling rough while cold I replaced teh temp sensor. After I did all this I began noticing that if the car sat still at idle for more than 3 or 4 minutes the check engine light would come an, and the engine would begin to stumble a bit. I checked the codes and it came back to a low voltage on the O2 sensor. Thinking the O2 was bad, I replaced it again.....to no avail.....it still does the same thing. I've never seen it do this before in all the years I've had it. Any thoughts anyone?
#2
Guest
Posts: n/a
I would say that you need to have a scantool hooked up to the car to see what reading the PCM is getting from that sensor...
Where are you located?
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Where are you located?
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Thread
Thread Starter
Forum
Replies
Last Post
lobi
Oldsmobile
16
02-24-2011 10:46 AM