Dual Climate control problems
Thread Starter
Junior Member
Joined: Sep 2013
Posts: 6
Likes: 0
Dual Climate control problems
99 Intrigue with Dual Climate Control. Drivers side does not blow any warm air. I am assuming it is a blend door servo. Can someone tell me where this is located? I would like to have a general idea before I start tearing things apart.
Senior Member
True Car Nut
Joined: Dec 2009
Posts: 9,616
Likes: 594
From: western,ny state
(1) Right Electric Actuator (w/ RPO CJ2 Only)
(2) Vacuum/Electric Solenoid
(3) Engine Vacuum Hose
(4) Blower Motor
(5) Blower Motor Control Module (w/ RPO CJ2) or Blower Resistors (w/ RPO C67)
(6) P100
(7) Heater-A/C Module
(
Left Electric Actuator
Senior Member
True Car Nut
Joined: Sep 2006
Posts: 4,816
Likes: 245
From: Windsor, Ontario / Detroit, Michigan
It is where the connector shown in Justin'* picture as #8 plugs into. When I changed mine I pulled the driver'* seat out, which allowed me to lay on my back with my head under the dash. Make sure you line the flat on the pivot rod up with the flat in the actuator. Other than that, its not too difficult to change.
I bought the new one off Rock Auto.
I bought the new one off Rock Auto.
Thread
Thread Starter
Forum
Replies
Last Post