P1362
09-27-2009, 10:58 AM
#1
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
P1362
P1362
Description
BY-PASS CIRCUIT SHORTED
Ignition Control Module (ICM) sends signals that the PCM
requires for fuel control and spark advance calculations. At the start
of engine crank, the ICM control spark advance (by-*** mode). When the
second 3X reference pulse is recognized by the PCM, PCM applies 5
volts to by-pass circuit, commanding ICM to switch spark advance to
PCM control (IC mode).
If PCM detects a short to voltage in by-*** circuit, DTC will
set. A short to ground in the IC circuit or by-pass circuit will cause
both DTCs P1361 and P1362 to set. Engine will start and run in by-pass
mode timing.
Symptoms
You likely won't notice any drivability problems.
Causes
Description
BY-PASS CIRCUIT SHORTED
Ignition Control Module (ICM) sends signals that the PCM
requires for fuel control and spark advance calculations. At the start
of engine crank, the ICM control spark advance (by-*** mode). When the
second 3X reference pulse is recognized by the PCM, PCM applies 5
volts to by-pass circuit, commanding ICM to switch spark advance to
PCM control (IC mode).
If PCM detects a short to voltage in by-*** circuit, DTC will
set. A short to ground in the IC circuit or by-pass circuit will cause
both DTCs P1361 and P1362 to set. Engine will start and run in by-pass
mode timing.
Symptoms
You likely won't notice any drivability problems.
Causes
- PCM detects a short to voltage in by-pass circuit.
- Locate and repair short in by-pass circuit.
- Replace IC control module.
