What did you do with your car/truck or shop today?
#2701
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
Well, got the new struts, hubs, and axles in place, also got brakes, sway bar and steering hooked back up and put the front wheels on. Now messing around with the vacuum lines, what a pain.
#2702
Senior Member
True Car Nut
Join Date: Jan 2011
Location: Michigan
Posts: 3,344
Likes: 0
Received 0 Likes
on
0 Posts
I have a wheel speed sensor out/going out... my abs always comes on when i hit my brakes and whats dumb is the place i got it from had just replaced one and i have the record of it so my brothers going to take it to his shop and run a test on it to see which one it is. I also need to get my alignment done one of these here days.
#2703
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 28 Likes
on
24 Posts
I replaced a hub on the Montana last year because the WSS went out. 3 months later, the same sensor went out. Some times they just don't last.
#2705
Retired
Sure you can Sarah. Just get a vehicle that has no sensors in it.
__________________
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
Retired Administrator
2002 *-10 5.7 V8
2023 Jeep Rubicon Diesel
#2707
Senior Member
Posts like a Turbo
Join Date: Aug 2009
Location: Indiana
Posts: 487
Likes: 0
Received 0 Likes
on
0 Posts
I extended the plugs for the MAP sensor and IAC valve and solder the wires at the starter on my truck. Also finished cutting the diamond plate for the dash in my truck.
#2708
Senior Member
Posts like a 4 Banger
Made a dump run with the branches the birds were using to **** me off, then loaded up the scrap iron and all the parts I've been swapping out of the PA.
For the fishin truck l ordered gaskets for lower parts of engine,a full clutch kit, and a complete exhaust system. That should take care of all the gaskets did the top side already have to do clutch an exhaust anyway so will just pull the motor and do it standin up.
For the fishin truck l ordered gaskets for lower parts of engine,a full clutch kit, and a complete exhaust system. That should take care of all the gaskets did the top side already have to do clutch an exhaust anyway so will just pull the motor and do it standin up.
#2709
Senior Member
True Car Nut
take the sensors out and clean them, there is a tsb for the early body style for salt areas crap getting in the sensors and lifting it slightly but enough to mess it up. the tsb only applies to a limited number of trucks but they didnt change the design significantly that i saw. my obs yukon looks exactly the same too and has the same problem, but they dont have that on there either. i think if you put a meter on there you are supposed to get 350mv ac if you spin the wheel.
#2710
Senior Member
True Car Nut
Join Date: Jan 2011
Location: Michigan
Posts: 3,344
Likes: 0
Received 0 Likes
on
0 Posts
Idk anything about that, me and my bro pulled the abs fuse temporarily which is even more annoying because the truck beeps at me for a while after I start it because the abs a nd brake lights are on... he'* gonna run tests on it Thursday at his shop