How do i program the remote control for my van?I have tried to turn on and off the ignition
while holding down the unlock button at the door.I looked to shortcut between pin 4 and 8
at the obd connector but there is no pin in 8.
Any ideas?
Ps the local dealer tried with the tech 2.He didnt make it.

Method 1 - No Tools Required, Program All Transmitters

Important
All transmitters which are to be recognized by the PDM must be programmed in a single programming sequence. When using this program method, all previously programmed transmitters will be erased upon the receipt of the programming signal from the first transmitter.

The order in which the transmitters are programmed will determine its numbering position within the PDM memory. The first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. The number stamped on the transmitter case is for reference only: #2 can be programmed as #1, or vice versa. Additional unnumbered transmitters are also available.


Close all the vehicle doors.
Insert the ignition key into the ignition lock cylinder.
Press and hold the door unlock switch.
While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
Repeat the previous step to program up to four transmitters.
Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter programming mode.
Operate the transmitter functions in order to verify correct system operation.

I already tried that method but nothing happens when i let go of the unlock button

Hi i have tried this but nothing happens

the dealer say anything about why it didnt work. something wrong with it?

No it was a young guy and he didnt understand much when things didnt work for him so tech 2 is tried holding the unlock button and cycling the ignition is tried another method tried is on and off with the ignition and reading a code that you are supposed to tap in with your brake pedal but i only get the first number wich is 8 its a blink code in the security lamp

No it was a young guy and he didnt understand much when things didnt work for him so tech 2 is tried holding the unlock button and cycling the ignition is tried another method tried is on and off with the ignition and reading a code that you are supposed to tap in with your brake pedal but i only get the first number wich is 8 its a blink code in the security lamp