Will Trans Am Rims fit?
Thread Starter
Senior Member
Posts like a Supercharger
Joined: Jul 2003
Posts: 168
Likes: 0
From: Barrie, Ontario
Will Trans Am Rims fit?
I'm looking at getting some Trans Am rims for my car. Think the years were 1988-1992, the deep dish black spoked with chrome outer type
Anyone know if they will bolt right on without any probs ? they are 16 x 8 -4.75 bolt pattern. I think they would look bitch'n with some phat rubber
Anyone know if they will bolt right on without any probs ? they are 16 x 8 -4.75 bolt pattern. I think they would look bitch'n with some phat rubber
Senior Member
True Car Nut
Joined: Jul 2003
Posts: 6,127
Likes: 1
From: Westerville, Ohio 2000 Black SSEi
Originally Posted by BlackBonEvil89
deep dish black spoked with chrome outer type
. -- Rogue
Senior Member
Posts like a Corvette
Joined: Oct 2002
Posts: 1,206
Likes: 0
From: N.W. Indiana
It probably wont fit because of the FWD & RWD offsets are different, but it still wouldnt hurt to try. Weve used my friends rims & sliciks of his GTP and used them on my other friends 96 Cobra. It was a real tight fit but it worked(had to kick the tire off).
Senior Member
Posts like a Northstar
Joined: Aug 2002
Posts: 602
Likes: 0
From: Toledo, Ohio 2002 SSEi
They are a different bolt pattern so they wont fit. Also, even if they did, the offset would put the outer edge of the rim two to three inches farther out than stock. A bit too much of the "ghetto fatty" look if you ask me.
Jay
Jay
Senior Member
True Car Nut
Joined: Dec 2002
Posts: 5,459
Likes: 2
From: Sauk Centre, MN
Find some factory lace wheels from a 1989-1994'ish Grand Prix. They are 16"x8". They look just like the Bonneville crosslace wheels, but if you look at the lip of the rim there is a lot more lip. Also look at the back of the rim to find out the true width of the rims, which should say something like 16x8JJ.
Good luck.
Stylez
Good luck.
Stylez
Junior Member
Posts like a Ricer Type-R
Joined: Aug 2002
Posts: 11
Likes: 13
Originally Posted by Rogue
Originally Posted by BlackBonEvil89
deep dish black spoked with chrome outer type
. -- Rogue
Senior Member
Certified Car Nut
Joined: Oct 2002
Posts: 11,308
Likes: 2
I need ceramic pads too...but I'll wait till I get the slotted rotors. Cleaning my wheels is a PITA, but this new wheel cleaner I found is amazing though 
Not as much scrubbing anymore.
But those TA rims would look awesome on your car! Maybe find some crosslace Bonne rims and paint them black. My ghetto golds look phat on RLD. Ask Jim, he'll agree.
Not as much scrubbing anymore.But those TA rims would look awesome on your car! Maybe find some crosslace Bonne rims and paint them black. My ghetto golds look phat on RLD. Ask Jim, he'll agree.
Thread
Thread Starter
Forum
Replies
Last Post