I had no clue as to what to get Oldsman for Christmas. So I finally decided on a ZZP Modular Pulley system with a 3.4 pulley. Sorry Boosty but since Enrique has to work 12 hour shifts from saturday all the way to tuesday I decided to give him his present early! We installed it without resetting the PCM and it we were seeing only about 1 degree of KR. So we reset the PCM and we will scan again after the PCM learns the new pulley!
Here are some pics!







Unfortunately when we finally got the new HUB and pulley on we were too excited to take more pictures. I am sure Oldsman will take new pictures of his new pulley!

WOOT WOOT! nice guys...

whose puller?

(Strikes arrogant pose!) I know I am a great guy!
Yeah we borrowed the tool from a guy in bayside named Sal (about a 20-25 min drive)
He has the tool to lend out. He is the owner of a very impressive 11.8 sec turbo grand prix!
We had a misshap with the center bolt stripping because an 8mm stud failed (the threads cleanly came off) when the hub was almost on! So we got replacement parts and then it went soothly. I have to admit after using that tool, I would not like to use it again for a long time. Getting the tool to turn felt like pulling teeth.

Hey Oldsman......I KNEW ABOUT IT!!!!!!

Did you read on how the tool failed . I drove for 3 days with no boost just to make matters worse the thing was have on . But now I have it on. HEHEHE. I left a 25 ft burn out (I let off the gas it had plenty more to go), Can't launch it for **** on wet road, highway passing power is far better too.


Merry christmas to me.