that is where i got mine from.. and the 9115 cable.
perhaps i need slug to make me a cable.
i was told the 9115 cable was the correct one from the guy i spoke to on the phone.

Slug was only charging $14 for his cables, I'll bet the cost off that web site was quite a bit more.

i changed my mind on the scanners... i want on that can do OBD1 and 2

what do you guys thinkg of the cp9145?

http://www.amazon.com/exec/obidos/AS...m-20/ref=nosim

looks good..

i should get one also..

i have a 9145. i like it very much. it has live data. and will work on 94-95.

9145 works well on all my vehicles. It actually pulls up the most info on my Bonny!

But the 9145 won't read enhanced data, including KR.

i had a scanner on there, and found no KR. i don't plan on doing any serious mods, so KR isnt a huge deal. what are the other "enhanced data" parameters?

I tried the scanner (9110)this morning.. my abs light came on as well as the traction control light.. probably a wheel sensor.

I plugged in the cartridge, connected cable to scanner and then to the obd port.
beep
scanner came on.. running test.
ram test ........... pass
rom test .......

and there it stopped.. waited about 5 min.. still nothing.
drove to work followed the same steps again.. no display on scanner.
i think its shot.
i also tried with the cig adapter.. still nothing.
with key forward as well as car running. no display .

cp9145 is on its way ..

Actually, it does. i saw 1-2 degrees at WOT on the 2-3 shift, but 0 the rest of the time. i couldn't read KR with OBD2 on my friend'* 99 alero, but it read fine on my bonneville. now to test the impala..

great scanner, i would reccomend it to guys with OBD1.5 especially. (or people with OBD-I and OBD-II cars)

among the intereseting things i found - KR, TPS voltage, IAT temps, trans temp, IGN timing advance...