How do you remove the face plate that covers the unlock/lock and window controls on the drivers side? I disconnected the door lock wire allready, now I need to know how to remove the wires from the plate so they will be seperated??

Disregard everyone. I pried it off with a screwdriver, and sliced my hand again.

Hrm... Did you get it off? if you did, then it'* worth it.

I just pushed the tabs holding the plate and it worked for me.... :?

Yea, I got it off. I am painting them glossy black. It looks a lot better then the stock gray. I will get pics up when I am finished with the whole car.

Haha, you know I was thinking about that, but I want to see how this looks for a little bit. I am also doing my trim on my dash and glovebox also. I went with glossy black and silver...it is looking pretty tight, and really flows with the car! I got everything drying off now. Back to the Pontiac emblem, I will probably put one underneath my hood on that carpet, like how some people have the SSEi logo on theirs.

Have the pontiac emblem on the switch panel light up red...

Yea, that would be tight. Just trying to get this done for now. And one piece of advice I found out, make sure you label the screws and where they go and dont lose any, or it could get really nasty!