need help yet agian for yet another problem with me car
Thread Starter
Senior Member
Posts like a Supercharger
Joined: Nov 2009
Posts: 182
Likes: 0
From: Oberlin, Ohio

well i sound like my tranny went but heres what happened i was on the highway crusin normal no beating on it and then i got off the highway stoped at a stop light and it turns green and the bonnie will barly move, it gets up to 2k 2.5 rpms and it just starting to move revese is normal. the motor was running hotter then normal and there was some smoke coming from under the front manifold but that could be left over oil from the day before putting more oil in it
sorry for spelling
sorry for spelling
Joined: May 2006
Posts: 29,661
Likes: 43
From: Sheboygan Wisconsin






Check your fuses, you should find one labeled misc engine may have cruise control on that circuit as well. If this goes out the trans will have little to no oil pressure and will slip like crazy but will still limp home. I seem to recall reverse will slip but not as bad.
Thread Starter
Senior Member
Posts like a Supercharger
Joined: Nov 2009
Posts: 182
Likes: 0
From: Oberlin, Ohio

what is the uniot that fuse controles cuz ever fuse keeps blowing i put in theres so im guessin there something wroung with that. i put a 20 amp fuse and it held a little long so it seem to want to move before it blew
Before you go tearing into the tranny, I would check every inch of the wire you can. A small cut in the wire could cause the short. Make sure nothing is melted etc. DO NOT put in a bigger fuse. The fuse is blowing for a reason, and circumventing that is just going to cause you bigger issues.
Thread Starter
Senior Member
Posts like a Supercharger
Joined: Nov 2009
Posts: 182
Likes: 0
From: Oberlin, Ohio

like ive said ive checked the wires i do not see a cut or melted wire and the it wasnt that much of a bigger fuse but that couple amp more fuse showed me it a electrical problem and not a tranny problem
Just making sure you REALLY checked the wires out. We had someone before tear the transmission apart and find out it was a wire.... lots of work to find out it was just a wire. I would hate for you to do the same.




