What would you pull from it?

Say it was hit in the front driver'* side, moving the engine some but the firewall back looked ok?

if it had my interior (camel two tone) I would steel the drivers seat.
or at least the bottom seat

Shift ****, center cupholder area of the console (if 2002 or newer), and the center taillight section!!

All the exterior lights.
All interior seats
Hood = Project time
Hood support struts
Trunk springs
PCM
Compass
DIC Module
Dash
Front Facia
Front and rear calipers
Steering wheel

Oh heck just purchase the entire car and take it home.

I need the driver side tailight.

as long as you don't pay more then 1000, you WILL make money

While this is a novel idea, it'* not possibly (already tried). But I will say that'* it is black...

I would go back to it, take as many pics of every part of the car, and then only sell parts that people request, marked up a tad for your work. You don't need leftover parts that won't fit on your car.

The driver seat, or just the bottom part, that'* it if the interior is the camel/tan/whatever it is

I would grab the lens cover for the gage cluster..... IF it was cheap