there is a grommet right behind the drivers side strut tower, its a bitch to get to but many have used that hole for routing wires including me

Where will the wires come out?

I ran my ground to one of the ground contacts for the body behind the battery.

I went thru the rubber tube in the door.

< Lazy

they will come out right behind the dash, if you remove the hush panel and follow the hood release cable from the dash to the firewall, that is where the grommet is, (that is the main puropse for that particular grommet, to get the hood release cable to the engine)

they should come with directions and supplied wireing

Well, I have the wiring for the halo'* all hooked up with the relay, fuse, ground, and the other cable that hooks to the battery attachted. Now, The wire that they give me isn't long enough to get to the whole in the firewall from the spot where the attachtment is near the battery (where I have the fuse relay). Is it possible to get an extension for this? There is no way I would be able to get the wire to the whole in the firewall and then be able to get the wires through to an accessable spot for the switch. Are there any other wholes that I can use? Help needed!!!!

Just make an extension. Get a few male and female spade connector like the ones used in the system, and some wire.

Are there any other places in the firewall or anywhere else that i can feed the wire through to the cabin? The one by the strut tower is hard, and I'm having a hard time getting the wire through there. Any tips?

You'll need an extension regardless i think.

Yea, I know that I am going to have to get an extension. The problem that I know have is how to get it through the firewall, or any other ways to get it into the cabin. Are there any different ways?