supercharger porting
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Jan 2005
Location: Melbourne, FL
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
supercharger porting
I'm planning on taking the rotor housing off of the M90 for cleaning and some mild porting since it'* off of the engine right now. Are there any seals that I'll need to replace while doing this?
#2
DINOSAURUS BOOSTUS
Expert Gearhead
You will need a tube of GM red gasket maker to seal the charger back together. Otherwise..you may also want to change the beraring in the back of the casing while you are at it. All stuff is linked on Wrens site about SC'*.. Most likely in the porting/cleaning phase you will get stuff in the needle bearings and need to replace them.
#3
Junior Member
Posts like a Ricer Type-R
Absolutely change the needle bearings after porting, or any time you're in there. It'* cheap, easy, and good preventive maintenance.
http://www.williamwren.com/superchargers
The information you need is mostly there.
http://www.williamwren.com/superchargers
The information you need is mostly there.
Thread
Thread Starter
Forum
Replies
Last Post
Speedster400
Performance, Brainstorming & Tuning
6
11-07-2007 09:51 AM
brminder
Performance, Brainstorming & Tuning
3
07-26-2002 05:49 AM