3.25" pulley....what belt?
#1
Senior Member
True Car Nut
Thread Starter
Join Date: Dec 2002
Location: Sauk Centre, MN
Posts: 5,459
Likes: 0
Received 0 Likes
on
0 Posts
3.25" pulley....what belt?
Yup, for the 99. I am wondering if anyone know'* the belt length for using the 3.25" pulley with no IC, and no oversized idler pulley on the H-body?
Need part # asap so I can get it to the shop tonight or tomorrow so I can have the motor and trans ready to drop in Thursday or Friday.
Need part # asap so I can get it to the shop tonight or tomorrow so I can have the motor and trans ready to drop in Thursday or Friday.
#2
Senior Member
Certified Car Nut
Join Date: Oct 2003
Posts: 19,756
Likes: 0
Received 0 Likes
on
0 Posts
you could use a 715 belt then go to the oversized tensioner....although this is not the best setup because of clearance issues between the tensioner and the supercharger
#3
Senior Member
True Car Nut
Thread Starter
Join Date: Dec 2002
Location: Sauk Centre, MN
Posts: 5,459
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, I just tried to figure it out via ZZP'* belts guide.
They don't give a belt # for anything less than the 3.4" for the H-body, so I figured it'* going to be the same drop in size as the W-body.
I am going to go with the 715 for now, and if that slips I'll just get a 710 and that'll be really snug.
They don't give a belt # for anything less than the 3.4" for the H-body, so I figured it'* going to be the same drop in size as the W-body.
I am going to go with the 715 for now, and if that slips I'll just get a 710 and that'll be really snug.
Thread
Thread Starter
Forum
Replies
Last Post