I pulled the codes from my 1990 when it failed to start and then when it did ran like crap. I got a code 22 which is the throttle postion sensor, so i replaced it along with the camshaft postion sensor. With both new parts it still is hard to start and run bad. I also still get the code 22. What should I try next?

Wiring and connectors

ken

The connector appears to be in fine shape. As far as the wire go the parts I can see a good with no cuts or kinks.

Did you check the connections at the ecm? Kind of a long shot from your previous post but only takes a minute to check?

I gave then a quick glance and test to see if they were snug but I will check again tomorrow.