Some stuff to come...
#1
Artist
True Car Nut
Thread Starter
Some stuff to come...
Got bored today on my day off (aka game servers down LOL) so I decided to start on clearing my tails. Just doing the center for now as I can't afford to not have the outers to drive to work tomorrow. Once done they will be cleared, tinted, and have red turn signals.
Yup duct tape covering the holes
Letting it sit inside in the A/C to get the humid air out of it before sealing with RTV and epoxy.
The Bonne will also be getting dropped off on the 29th at a local body shop to have the stupid fuel door rust repaired finally.
Yup duct tape covering the holes
Letting it sit inside in the A/C to get the humid air out of it before sealing with RTV and epoxy.
The Bonne will also be getting dropped off on the 29th at a local body shop to have the stupid fuel door rust repaired finally.
#4
Artist
True Car Nut
Thread Starter
#7
Artist
True Car Nut
Thread Starter
#8
Artist
True Car Nut
Thread Starter
800/1000/2000 grit wet/dry sandpaper and Meguiars PlastiX. Took them off for the sanding and used my drill to polish them after putting back on the car.
Before:
After:
Oh and, IN BEFORE SOMEONE SAYS CLEAR THAT AMBER! It stays as it always will and always has.
Before:
After:
Oh and, IN BEFORE SOMEONE SAYS CLEAR THAT AMBER! It stays as it always will and always has.
#9
Senior Member
True Car Nut
They do look pretty good now though.
Thread
Thread Starter
Forum
Replies
Last Post
wjcollier07
Lounge
12
11-23-2006 09:43 PM
Burgundy_Boat
General GM Chat
29
12-28-2003 06:01 PM