Okay so the other day I had the dremel out, reworking the inside of the dash for a better fit for my head unit, and I got this idea. Why not dremel out the Pontiac lettering on the front bumper and then stick some neon behind it, to light it up.. Here'* where the story goes terribly awry. When doing the O my hand slipped and took a little too much out.

The other letters look pretty decent. I would like to get a plate made of the polished material, and have the Pontiac letters cut out on the plate. Does that make sense??

Does anyone know of anyplace that would do such a creation??

Round Two will go to the Bonny.

Thanks for any info.

Tim

emachineshop.com

Are you talk about the license plate cover on the middle of the bumper?

One of my friends in high school tried the same on the rear of his GTP. Turned out terrible but he was never good with tools to begin with.

yeah, that'* what I'm talkin about. I'm usually pretty decent with tools my hand just slipped. I'll get it straightened out though.


Thanks for the site Dame.

Tim