might be the one you're looking for:

The blend door moves between the cold and hot sides while the mode door moves between the floor/vents/defrost.

thank you

I had removed the old mode door actuator and opened it up and found a plastic gear that had a crack, I replaced with a new mode door actuator and tried the new one and it will not direct the air flow to the mid vents, i crawled under the dash to see if the new mode door operates and it does move, I am at a loss as what the problem might be???????????

I have replaced the mode door actuator with a new actuator and it does not work, the old one I took out had a cracked plastic gear, therefore I am stumped

sorry for the same message

If the ducts get warped the door may only open part way. Can you verify it opens and closes completely?

unfortunately I did not test the range of motion of the flappers when I had the old actuator off, I guess I will have to pull the new one off and check if any of the door flappers are stuck, man I hate to have to do that, it took me 8 hours on my back at a 45 degree angle under the dash, but I guess thats what Ill have to do to find out , perhaps i can squirt some silicone lubricant on the levers on the outside of the flappers

Just use your fingers and see if it sticks. Should open and close without any restriction.

Thanks, also there should be a law against the kind of thing!!!!!