I have a 98 PA the door roller is making a racket, my searches only turn up the roller that is part of the hinge. Mine is separate as many know! I had the panel off a year or so ago to replace the arm rest switches. The roller was a little noisy so I tried to see if I could fix it, did not see any access so I gave up. I buddy just gave me a new roller so I am again motivated to give it a look see. I am hoping for guidance all input appreciated!

Phil

Are you talking about the door check? Or the window regulator? these are the only two things I see in diagrams that have a roller. the door check is the rod that comes out of the door by the hinges and bolts to the A pillar.
Post a pic of the part you have if you can.

As requested photos attached! Top shot shows door open limiting bar, below is the new roller.

Phil

I looked at a diagram on wholesalegmpartsonline.com. I didn't see a roller anywhere. the pic you posted is the door check. it'* to stop the door from swinging open. unless the roller you show is inside the door, I don't know where it'* at. I can't find any good pictures of it. here are a couple. but I can't tell where the roller might be. note one picture is one way and the other is flipped. so we can see it from both sides. GM part number is 19244695.
anybody else have any ideas? chime in.

Thanks the photo clears the issue up nicely!

Looking at the photo it shows the roller is in the bracket, what was given to me was just a roller. It is a complete assy as shown by the photo, need to look into how to change out the assy..
Phil