So, I recently replaced the rear air Shocks with the conversion kit. I've pulled the relays, fuses, etc., 3 in total, that control the system. Unfortunately, my wipers are tied into the fuse for the air pump. Idk. But, I need to wire in the resistors that came with the rear conversion kit. There are instructions stating to install it, but no wiring colors. Hell, it doesn't even SAY WHAT wires to do this with. There is the wiring harness that plugs into the compressor itself, under the passenger rear & there'* also a harness to the load level itself, under the driver'* rear near the tire. Can someone please give me some guidance. I've been searching for nearly 2 weeks. There is nothing online. Only people asking the same question, only to have a group of people argue in the thread about something completely different. I need to wire in 2 resistors so I can get my wipers working & pull out the compressor & tubing. Someone, PLEASE help.

Thanks in advance!

Welcome to the site.
I did the conversion on my Park Ave & all I had to do was remove the compressor fuse under rear seat, but I'm sure the wiring would be different on your Lesabre.
I'd try disconnecting the compressor harness & see if that works alone with other fuses then re-installed & see what happens.

Did you get a shock that has 92-99 lesabre Command Computer Ride or whatever? There should be zero need to use resistors. Show us the kit. Strutmasters?