So me and a buddy was installing HID on the GXP (headlights & Fogs HID) so We got the headlight done, and started on the fogs. we got the connectors modded and went to put the HID bulb in and broke the inside of the fog housing.. lol It was pretty funny b/c we thought the bulb was breaking... But Needless to say we stopped and decided not to mess around with the other fog till i got a new fog light assembly.. Does anyone know where i can pick one of these up? I seen a few on ebay every now and then but there is non on there now. Im not in a rush to get it but would like to have it soon..

here ya go one for each side
http://cgi.ebay.com/ebaymotors/NIB-O...item3caab783d2
http://cgi.ebay.com/ebaymotors/NIB-O...item3caab78a2f

Great.. Thanks for the quick reply!!! the passgener side is the one that got broken.. Thats alot of money order the wrong one, So that would be the right side fog that i need right?

yes you need the right hand one

How in the world did you break it? I installed my the HID'* on my fogs without any problems aside from the cover cap not going on because of the limited clearance.

Thanks.. And good looking out with the quick reply and links...

I have no idea, i know i was pushing on the clip pretty hard to get it to hook on.. but other than that, thats all i know.... when i get the fog light assembly in im going to put the hid light in before i install it onto the car.. and same for the left side.... But hey aside from timing the 9006 hole for the 9006 headlight HIDs those went in great...

When i take out the fog assembly, is the lens on the out side of the front bumper connected to it? or will it still be in place when i take the assembly out?

Got the new Fog light assembley in on thursday and installed both HID kits (fogs and re installed the headlights) and they look great!!! I also replace the V8 with a Northstar V8 Emblem...
Pics....

New Left fog assembly


Old Right fog assembly (thinking about getting a new one for this side if it don't clean up close to the new left side)


Ballast installed for the headlights.. ( Fogs ballast is already installed)



The GXP hanging out with my Intrepid that i just installed a new radiator in


Out with the old V8 emblem and in with the new Northstar V8 Emblem









Thanks for the help peeps!!!

xtremerevolution & Bville_GXP

how did you guys seal the fog light since the cap wont fit? mine is done but just curious

Good question..... I haven't installed the cap on mine as of yet b/c i have not found another way other than to drill a hole into the cap big enough for the wires to run through it to the ballast.... Do you have any good suggestions?