Glueing wouldn't allow it to go into the notches right, if at all. How are you using the shifter right now. I'll wait for Pat to chime in here, I'm not sure about shifters and hope mine stays intact.

Well i can just stick it back in and it works great, but once i let my thumb off it, it falls to the floor!!! Looks like the "hook" is broke at the tip.... But I just located some info about this part that i think we all may like.... Its a GM parts book and if it is a "shifter retainer" # 34 then it'* only $1.98...


Please select a corresponding number from the illustration below to view the details of that part.
1) Console body Neutral 2) Console body Front bracket 3) Console body Rear bracket
4) Console body Side bracket 5) Console body U-nut 6) Compartment box
7) Door assy Neutral Hinge 9) Cup holder Neutral
10) Latch 11) Liner 12) Rear housing Neutral
13) Ashtray housing Neutral 14) Ashtray Neutral 15) Power outlet
16) Power outlet Retainer 17) Air duct Front 1 Air duct Center
19) Air duct Rear 20) Air valve 21) Link
22) Air deflector Neutral 23) Compartment Neutral 24) Compartment Mat
25) Lighter 26) Lighter Housing 27) Lighter Retainer
2 Lighter Connector 29) W/o traction control or seat heater Neutral 30) Ashtray
31) Shifter 32) Shift boot 33) W/o leather Neutral
34) Shift **** Retainer 35) Seat heater Seat heater Back 36) Switch Traction control
37) Wire harness


Athttp://www.gmpartsdirect.com/catalog/frameset.cfm

that retainer holds the **** to the shaft already tried that one when mine broke

my button is fine but the linkage that pushes down on the other thingy broke so i was stuck in either drive or neutral and sucked cause i was nosed in against a curb

dang, that sucks................

Im still looking for a GXP shifter.... I came across a real 2005 GXP Shifter on ebay 2 weeks ago, but to me it looks like it could break soon also and for $60 i would be pissed if it broke!! So Anyone have any leads on a good used one? Im going to pick up a 2000 and up type shifter to use till i can get a GXP one b/c this rubber band thing around the shifter is just not working out... lol

if i find another one i will let you know. i got myself a complete GXP front end from a bone yard when i go pick it up i will check on the shift **** for ya

mine broke a month or so ago and it was covered under my extended warranty
even the new one, it looks like its gonna break soon

PM sent...


Humm.. I didn't think about that!!! I'm going to call the dealership tomorrow and see if mine is also covered under the extended warranty...

So i called the dealership (toyota) and it'* not covered under my extended warranty.. So today i was at the local LKQ (u-pull) yard getting stuff and seen a 2000 Impala with black shift ****.. Got it, Cleaned it and put it on the GXP and it fit perfect!! Cost was only $1.99 for the shift **** too!