Remote car starter

Reply Subscribe

Thread Tools

Search this Thread

Dec 31, 2004 | 01:32 PM

#31

vital49

Thread Starter

Junior Member

Joined: Mar 2003

Posts: 1

Likes: 5

From: Purgatory

Quote:

Originally Posted by randman1

You would simply have to connect 2 wires from the module to wires in the driver'* door jamb boot. Can you scan the wiring diagram so I can take a look at the pin-out? If not, I can usually find installation manuals online.

There'* a chance that you'll need the wires too. From what I remember about Viper equipment, the door lock outputs are a separate plug-in harness with 2 or 3 wires. When I would install equipment without those options, I would omit the harness as well. It makes the install just that much cleaner. Not to worry, though. I probably have something laying around here that will work.

Thanks for the tip! The manual didn't come with a wiring schematic. It'* only the owner'* manual. The box is stamped all over with "Installation to be done by a licensed professional only." So, it would make sense that they didn't include the schematic.

Dec 31, 2004 | 01:39 PM

#32

randman1

Senior Member

True Car Nut

Joined: Feb 2004

Posts: 2,708

Likes: 2

From: Western MA

That'* OK. I talked to a buddy about 5 minutes ago that works with DEI product daily. He confirmed that the lock wires are a separate connector and that they are negative trigger. I also dug up the connector if you need one.

You'll have to poke your head up under the dash to see if the wires were omitted. If they are there, we can get started whenever you're ready. If not, PM me with your address so I can get the harness to you.