Audio (and aftermarket electronics) This is your place for alarms, remote starters, to brag about your system, exaggerate your db levels, or simply ask questions for stock or aftermarket audio. No Flames! (except from roasted amps)

Rear speaker help!!!!!

Old Apr 23, 2004 | 12:08 PM
  #1  
suppastar56's Avatar
Thread Starter
Junior Member
 
Joined: Apr 2004
Posts: 5
Likes: 0
suppastar56 is on a distinguished road
Default Rear speaker help!!!!!

How did you guys take out your factory speakers and put the new ones in?
Because i just bout 6X9'* and the mounts to my old speakers don't fit my new speakers.So did you guys buy new mounts or just put them in the way the new speakers are?
I have a 1993 Bonneville.
Any help would be greatly appreciated...
Reply
Old Apr 23, 2004 | 04:12 PM
  #2  
CFoote's Avatar
Senior Member
Posts like a Camaro
 
Joined: Dec 2003
Posts: 1,019
Likes: 0
From: Massachusetts
CFoote is on a distinguished road
Default

Your '93 should allow the speakers to fit right in.

Are you sure you aren't using some silly adapters that came with your new speakers?
Reply
Old Apr 23, 2004 | 06:02 PM
  #3  
russianpolarbear's Avatar
Senior Member
Certified GM nut
 
Joined: Apr 2003
Posts: 1,867
Likes: 0
From: Davison,Michigan
russianpolarbear is on a distinguished road
Default

What kind on aftermarket speakers we taliking here??
Reply
Old Apr 23, 2004 | 11:36 PM
  #4  
ssesc93's Avatar
Senior Member
True Car Nut
 
Joined: May 2003
Posts: 7,262
Likes: 0
ssesc93 is on a distinguished road
Default

go to the truck and open it. Then look for your 6X9'* and push up on it hard enough to unhook them form the clamps. I will tell you the rest later because I dont remember what wrench to use to unscrew the speaker upholster.
Reply
Old Apr 24, 2004 | 11:02 PM
  #5  
glanghus's Avatar
Senior Member
Posts like a Turbo
 
Joined: Mar 2004
Posts: 230
Likes: 0
glanghus is on a distinguished road
Default

Sounds funny...6x9'* should fit just fine...
Reply
Old Apr 26, 2004 | 12:05 PM
  #6  
excessive81's Avatar
Senior Member
Posts like a Turbo
 
Joined: Dec 2003
Posts: 248
Likes: 0
From: INDIANA
excessive81 is on a distinguished road
Default

if they really will not fit then you can make them fit with some 1/4" wood of some sort. just trace the old speaker top onto the wood and then the new one. you should end up with a thin piece of wood that will screww into the stock location and then you mount the new speaker to the wood. i have never had to do this with a 6x9 though are you sure that is what you got?
Reply
Old Apr 27, 2004 | 05:35 AM
  #7  
StoopidSavant's Avatar
Senior Member
Posts like a 4 Banger
 
Joined: Dec 2002
Posts: 147
Likes: 0
From: New Jersey, USA
StoopidSavant is on a distinguished road
Default

suppastar56,

I had the same problem when I installed my Pioneer TS-A6995'* last year. I'm assuming that you mean that the black plastic bracket that holds the stock speaker in place doesn't fit your new speakers?

In my case, the Pioneers were a little too big, so all I did was take a utility knife and start carving away the opening of the bracket until it did fit. The plastic is fairly soft, so you shouldn't have a problem if you have a sturdy enough knife, I don't recommend an exacto knife since they're kinda flimsy and you'll dull the blade very fast. If you can get a proper utility knife, trimming away the excess plastic should be no problem.

Good luck!
Reply
Old Apr 27, 2004 | 05:44 AM
  #8  
J Wikoff's Avatar
Senior Member
Certified Car Nut
 
Joined: Mar 2003
Posts: 12,433
Likes: 2
J Wikoff is on a distinguished road
Default

as in I had the same experience with my Pioneer 6x9'*. Shave away...
Reply
Old Apr 27, 2004 | 12:42 PM
  #9  
excessive81's Avatar
Senior Member
Posts like a Turbo
 
Joined: Dec 2003
Posts: 248
Likes: 0
From: INDIANA
excessive81 is on a distinguished road
Default

so they are to big not to small. yes then trim away but i would use a dremel tool to do it so you have a better chance of walking away with 10 fingers and so it looks better.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Cruzeguy17
Audio (and aftermarket electronics)
4
Oct 6, 2012 08:10 PM
jwagner
Audio (and aftermarket electronics)
9
Jun 20, 2006 10:09 PM
Black_Bonnie89
Audio (and aftermarket electronics)
7
Aug 27, 2004 09:42 PM
jachin
Audio (and aftermarket electronics)
12
Oct 31, 2003 11:20 PM


Thread Tools
Search this Thread

All times are GMT -4. The time now is 04:46 AM.