Audio (and aftermarket electronics) This is your place for alarms, remote starters, to brag about your system, exaggerate your db levels, or simply ask questions for stock or aftermarket audio. No Flames! (except from roasted amps)

Rear Deck Sound Dampening

Old Jan 26, 2006 | 10:35 PM
  #1  
mobbdeep389's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Jan 2006
Posts: 64
Likes: 0
mobbdeep389 is on a distinguished road
Default Rear Deck Sound Dampening

i just purchased a bunch of dynamat and i think i want to apply it around my 6x9s on the rear deck under the carpeting. could anyone give me instructions on how to lift up the rear deck carpeting? also should i even do this since the speakers are in grilles? anyone done this before?
Reply
Old Jan 26, 2006 | 10:37 PM
  #2  
corvettecrazy's Avatar
Senior Member
True Car Nut
 
Joined: Jun 2004
Posts: 6,182
Likes: 0
From: Rochester, NY (college)
corvettecrazy is on a distinguished road
Default Re: Rear Deck Sound Dampening

Originally Posted by mobbdeep389
i just purchased a bunch of dynamat and i think i want to apply it around my 6x9s on the rear deck under the carpeting. could anyone give me instructions on how to lift up the rear deck carpeting? also should i even do this since the speakers are in grilles? anyone done this before?
search for rear seat removal. then getting the deck out is self explainatory.

and yes, people have sound deadened the rear deck.
Reply
Old Jan 26, 2006 | 10:44 PM
  #3  
mobbdeep389's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Jan 2006
Posts: 64
Likes: 0
mobbdeep389 is on a distinguished road
Default

any instructions on how to remove the seat?
Reply
Old Jan 27, 2006 | 12:06 AM
  #4  
Plurr's Avatar
Senior Member
Posts like a Camaro
 
Joined: Feb 2003
Posts: 1,004
Likes: 0
From: Indianapolis, IN / West Lafayette
Plurr is on a distinguished road
Default

remove bottom of seat by pushing in and pulling up and it should pop out. (gotta use some force) then you will have to remove the top of the seat by removing the nuts out of the bottom (where the seatbelts are connected and a couple of other ones) then after that there are a couple of pushpins in the front of the deck, those just pop out. you will also have to pop out the pillars which are also held in by push pins. i think thats about it.
Reply
Old Jan 27, 2006 | 12:14 AM
  #5  
Hans's Avatar
Senior Member
True Car Nut
 
Joined: Jul 2004
Posts: 7,545
Likes: 1
From: Twin Falls, Idaho
Hans is on a distinguished road
Default

Originally Posted by Plurr
remove bottom of seat by pushing in and pulling up and it should pop out. (gotta use some force) then you will have to remove the top of the seat by removing the nuts out of the bottom (where the seatbelts are connected and a couple of other ones) then after that there are a couple of pushpins in the front of the deck, those just pop out. you will also have to pop out the pillars which are also held in by push pins. i think thats about it.
are you running your subs open air??!!!!
Reply
Old Jan 27, 2006 | 07:27 AM
  #6  
Plurr's Avatar
Senior Member
Posts like a Camaro
 
Joined: Feb 2003
Posts: 1,004
Likes: 0
From: Indianapolis, IN / West Lafayette
Plurr is on a distinguished road
Default

the 2 in the back deck are runnin free air and they are only half rms so they are fine. sound quality actually is pretty good and they are pretty loud for out of the box sub, but I chose to put them there more for show than anything else anyways.
Reply
Old Jan 27, 2006 | 10:16 AM
  #7  
JimmyFloyd's Avatar
Senior Member
True Car Nut
 
Joined: Feb 2002
Posts: 3,993
Likes: 0
JimmyFloyd is on a distinguished road
Default

just be careful removing the pillar trim. it is east to break the mounting tabs on those. Seat removal sounds about right as described about. 2 15mm bolts if I recall correctly, and two 18/19mm nut thingies on the sides that I used an open ended cresent wrench for. Oh, there are two plastic pushpins on either side of the passthrough that need to be removed two. can access from trunk or reaching in the passthrough. Halfway down it on either side. I forgot these when I tried and for 15 minutes I tried getting the seat out. then I remembered. with the rear deck, make sure to disconnect the tweeters if you have them before removing it. lastly, it might need to be wiggled out as they can be in there good.
Reply
Old Jan 27, 2006 | 06:07 PM
  #8  
mobbdeep389's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Jan 2006
Posts: 64
Likes: 0
mobbdeep389 is on a distinguished road
Default

could someone show me a picture of what the pillar is that you're all talking about?
Reply
Old Jan 27, 2006 | 08:51 PM
  #9  
Plurr's Avatar
Senior Member
Posts like a Camaro
 
Joined: Feb 2003
Posts: 1,004
Likes: 0
From: Indianapolis, IN / West Lafayette
Plurr is on a distinguished road
Default

the plastic pillar between the back windshield and the backseat windows (i covered mine in gucci fabric)
Reply
Old Jan 27, 2006 | 09:41 PM
  #10  
mobbdeep389's Avatar
Thread Starter
Member
Posts like a V-Tak
 
Joined: Jan 2006
Posts: 64
Likes: 0
mobbdeep389 is on a distinguished road
Default

ok
Reply

Thread Tools
Search this Thread

All times are GMT -4. The time now is 12:17 AM.