ok everything is ready, but i cant find a grommet in can get though....

there is two places i can find right in front of the driver side... one has a thin wire but that one seems to be made just to wrap around that


the other holds a much bigger wire, that is foam, and i can slide the wire around with it but i cant fit another 4 guage wire into it

this is where i ran mine through its on the drivers side right behind the strut bar.

you can get through on the passenger sid also but the main link

thats where im trying but i jsut spent 2 hours trying to get the grommit out

any suggestions?

get a screw driver and wrap tape around the wire and the screw driver and push it through

I've never pulled a grommit out in 3 full installs. Just poke a hole, or go around the firewall...

thats the way i do it too

the way i did it is i ran another piece of wire through the other side and electrical taped it to the wire i was pulling through and pulled it...i also used a little bit of soap to make it slide better.

that works too

oh yah and i dont think the screwdriver thing would work on this one cuz its at such a sharp angle you can also check my website cuz it tells some about it too (3rd page)