cd player problems
i got my wife a kenwood mp7028 and i installed it with no problem and the radio works fine it has sound BUT when i try to play a cd it plays fine but thier no sound comeing out of the speakers.
i checked the wireing its fine and if it wasnt the radio wouldnt have any sound. any ideas before i call the place i bought it from? |
Turn your cd's over?
|
Originally Posted by willwren
Turn your cd's over?
|
Check your flux-capacitor????
Check your settings in the deck...I know mine has some wierd setting that screws up the speakers |
You used the wrong wire as your remote turn on lead. The Kenwood harness has a blue wire (Power Ant. turn on, only active while listening to AM/FM) and a blue/white wire (Amplifier turn on, active while radio is playing any source). Use the blue/white wire.
|
i hope right but as of right now i have my remote wire going to the wire that says P. CONT
and the wire that says ANT CONT goes to the amp turn on of the wireing harness. ill switch them around and try it. |
If you verify the wiring to be correct, the unit probably has a bad DAC. Hopefully it can be bench tested at the place of purchased then either replaced or repaired under warrenty.
|
Put the ANT wire to the antenna and the AMP turn on wire to the amp. I've got the MP8025 and it works well that way. Are you pushing an amp?
|
i figured it out. i changed thw wires like u said, i will be putting an amp in for the subs i ran all the wires except the power wire cuz i still gotta find a way to get in thw car with out drilling.
|
i put a amp on and the amp only work with the radio on? is it the same wire thing again?
|
All times are GMT -4. The time now is 01:00 PM. |
© 2024 MH Sub I, LLC dba Internet Brands