Trunk Liner Thingy Problem
Thread Starter
Member
Posts like a V-Tak
Joined: Sep 2004
Posts: 55
Likes: 0
From: St. Michael, MN
Trunk Liner Thingy Problem
The liner that is up against the back of the trunk (with the opening from the backseat) keeps falling off. I have used carpet tape but that didnt work long. Any ideas on how to permanently fix this (other than to let it lay where it falls or take it out completely). I didnt see any clips but maybe they were already gone when I bought the car...this has been an issue since I got the car, I just forget about it until I need to use the trunk. lol
The only thing I can come up with for a fix is to use some of those plastic cable ties to hold it to the frame somehow. :?
The only thing I can come up with for a fix is to use some of those plastic cable ties to hold it to the frame somehow. :?
Senior Member
True Car Nut
Joined: Oct 2002
Posts: 2,703
Likes: 0
From: Groton, CT _NEBF 05, 06, 07_
There should be two magnets attached to that panel. Are the magnets still on the frame section possibly detached from panel? If so, then re-epoxy the magnets to the liner panel.
Junior Member
Posts like a Ricer Type-R
Joined: Sep 2005
Posts: 13
Likes: 0
From: Rochester,NY
There is actually a TSB about that. Oddly enough it involves plastic ties 
The idea is to basically remove the thing, unscrew the two long narrow things that go towards the back of the vehicle, and take them off, then put the liner back against the back seat and tie with two ties through the holes formerly occupied by the screws holding the long pieces. TSb # 00-080660003A rear Seat Back Trim Loose/Sagging.
they give two solutions- the one above is for 2000-2001, and the second one mentioned by markwb for 2002-2003- reglue the magnets
The idea is to basically remove the thing, unscrew the two long narrow things that go towards the back of the vehicle, and take them off, then put the liner back against the back seat and tie with two ties through the holes formerly occupied by the screws holding the long pieces. TSb # 00-080660003A rear Seat Back Trim Loose/Sagging.
they give two solutions- the one above is for 2000-2001, and the second one mentioned by markwb for 2002-2003- reglue the magnets
Thread Starter
Member
Posts like a V-Tak
Joined: Sep 2004
Posts: 55
Likes: 0
From: St. Michael, MN
Originally Posted by reagle
There is actually a TSB about that. Oddly enough it involves plastic ties
I'll have to see if there are any magnets stuck anywhere....if not, I'll buy some and glue about 10 on there and maybe it will stay in place.
If that fails, then it'* plastic tie time. The only thing with that is if you dont get them tight the thing is going to make noise. :? Thanks for the info!
Thread Starter
Member
Posts like a V-Tak
Joined: Sep 2004
Posts: 55
Likes: 0
From: St. Michael, MN
Originally Posted by markwb
There should be two magnets attached to that panel. Are the magnets still on the frame section possibly detached from panel? If so, then re-epoxy the magnets to the liner panel.
Senior Member
True Car Nut
Joined: Oct 2002
Posts: 2,703
Likes: 0
From: Groton, CT _NEBF 05, 06, 07_
Yeah, Okay, good deal. Glad you figured it out, and yes, I do remember there are 3 magnets. I haven't looked at mine in a while. I had a similar problem a couple years ago. 
Thread
Thread Starter
Forum
Replies
Last Post
