if Pdad or someone has one, I cant get the center clip to go back in, now the panel is not as strong as before...also its a Pain in the butt to mess with those things!! tried to fix the leak.... kinda did on the front, i believe the rear driver is fixed...... where did the connectors for the power clip on 2?!?!?!? GM sucks!! cheap plastic deflectors. sorry needed to vent!!

As far as the 360 clip ( V shaped spring steel clip ) goes if that'* what you're referring to, you'll have to remove it from the nylon nut on the door trim panel with needle nose pliers, then install the 360 clip in the nylon nut down into the grooves on the inner door panel. Now you can get the door trim panel in place, make up the electrical connector, start at the bottom when re-installing the door trim panel. That 360 clip will then lock into the nylon nut on the inner door panel. Also make sure the top of the trim panel is seated into the strip at the window. Pull on the armrest, there should be no give there. Hope this helps a little. It'* alright to vent, believe me, I know what it'* like. I've messed with these lousy water deflectors many times on my rig.

alrite that sounds like a plan!! thanks mark

http://www.bonnevilleclub.com/forum/...ic.php?t=11704

This post shows some digrams on how to remove the door panel and put it back on. ark is bang on with the arm rest clips, if you get them set up the door skin will pop right on.

Thanks PDad!! ill give it a shot in the next few days!!

is P/N 25742368 the correct one for the deflecter??? wait....didnt we go over this not the long ago?!?!?

wait which deflector?
the one in the door?

yeah door... sorry!!