torque specs for axel nut, caliper bolts and torx for hub
#1
torque specs for axel nut, caliper bolts and torx for hub
First attempt at changing pads, rotors and wheel hubs on 1994 Bonneville SE; quite a challenge because I did not know I would need 3/8 allen and T55 Torx to disassemble. Have everything mostly together, but have been unable to find specifics for torque settings. Any help or advice is greatly appreciated!
Also, brake bleed screw is completely stuck......
Also, brake bleed screw is completely stuck......
The following users liked this post:
CathedralCub (12-05-2023)
#2
Senior Member
True Car Nut
I think the hub-to-knuckle bolts are 75lbft and the torx is 40lbft. Wheel lug nuts are 100lbft.
From memory so use at your own risk.
For the bleed screw, be careful working it open, otherwise it will likely break. If you're not changing calipers and the pedal isn't soft, you shouldn't need to bleed anything.
From memory so use at your own risk.
For the bleed screw, be careful working it open, otherwise it will likely break. If you're not changing calipers and the pedal isn't soft, you shouldn't need to bleed anything.
Thread
Thread Starter
Forum
Replies
Last Post
goldfinger22
1992-1999
4
04-20-2008 07:33 PM