1992-1999 Series I L27 (1992-1994 SE,SLE, SSE) & Series II L36 (1995-1999 SE, SSE, SLE) and common problems for the Series I and II L67 (all supercharged models 92-99) Including Olds 88's, Olds LSS's and Buick Lesabres Please use General Chat for non-mechanical issues, and Performance and Brainstorming for improvements.

Tanny Cooler more fluid?

Old Mar 10, 2005 | 04:06 PM
  #1  
neekolas's Avatar
Thread Starter
Senior Member
Posts like a Supercharger
 
Joined: Dec 2003
Posts: 158
Likes: 0
From: Menomonee Falls, WI
neekolas is on a distinguished road
Default Tanny Cooler more fluid?

i just have a quick question concerning the installation of a supplemental tansmision cooler on my 92 SE, once added, do i need to compensate the fluid level in the transmision due to the entraind fliud that is in the cooler and additonal lines during opperation, (I am doing a filter and fluid change when im doing the install)
the cooler is about 12" by 7"
thanks

nickyyyyyyyyy
Reply
Old Mar 10, 2005 | 04:11 PM
  #2  
mkaake's Avatar
Senior Member
Posts like a Camaro
 
Joined: Jan 2004
Posts: 1,166
Likes: 1
mkaake is on a distinguished road
Default

yes, you'll need more fluid. how much? dont know. keep an eye on that dip stick.
Reply
Old Mar 10, 2005 | 07:54 PM
  #3  
opensourceguy's Avatar
Senior Member
True Car Nut
 
Joined: Apr 2004
Posts: 4,879
Likes: 6
From: Three Oaks, Michigan
opensourceguy is on a distinguished road
Default

Since you need extra fluid, fill it up to the highest part on the "FULL" of the dipstick. That way you aren't going to starve anything.. or at least as bad as you could possibly.

Also, you know how you fill up your oil filter with oil before putting it back on the car? Well, fill up the tranny cooler with ATF, before putting it in the car [this could be difficult, depending on how you have your'* mounted]. This will help a lot with any dry start issues. If you can manage it, try pouring some down the lines to it, also.. but that may be overkill.


-justin
Reply
Old Mar 10, 2005 | 08:03 PM
  #4  
neekolas's Avatar
Thread Starter
Senior Member
Posts like a Supercharger
 
Joined: Dec 2003
Posts: 158
Likes: 0
From: Menomonee Falls, WI
neekolas is on a distinguished road
Default

i dont typicly, fil my oil filter up with oil before spinning it back on.....is that a good idea, I do hear the lifters for a few seconds wene i start it up after an oil change before the pressure gets up there......do you do that justin.....I may try that next time.......

good idea about filling it up what I may do is conect the flexible lines up first then ill leave it hang in frount of the condeser, then disconect the upper on and filler up with as much fluid i can get in there........are air bubles a prob in our transaxles, or will the bubbles work themselves out gradually with out much problem??? thanks for the suggestions and awnsers guys!

nickyyyyyyyyyyyyyyy
Reply
Old Mar 11, 2005 | 02:12 AM
  #5  
CSFiend's Avatar
Senior Member
Posts like a Northstar
 
Joined: Apr 2004
Posts: 566
Likes: 0
From: Minneapolis, MN
CSFiend is on a distinguished road
Default

Not to doubt you Justin, but I don't beleve that a few seconds of air in the lines, which are quickly being purged by the pump pushing fluid, will cause ANY damage. Heck, I still haven't fixed my tranny leak and going around corners when my fluid is low, my transmission slips because it'* lost fluid pressure....and I've been driving it like this since I did my TCC solenoid about 10K miles ago. No problem as long as I keep the fluid topped off (and figure out when I want to do that $#%^ side cover again).
Reply
Old Mar 11, 2005 | 11:16 AM
  #6  
mkaake's Avatar
Senior Member
Posts like a Camaro
 
Joined: Jan 2004
Posts: 1,166
Likes: 1
mkaake is on a distinguished road
Default

Originally Posted by opensourceguy
Since you need extra fluid, fill it up to the highest part on the "FULL" of the dipstick. That way you aren't going to starve anything.. or at least as bad as you could possibly.

Also, you know how you fill up your oil filter with oil before putting it back on the car? Well, fill up the tranny cooler with ATF, before putting it in the car [this could be difficult, depending on how you have your'* mounted]. This will help a lot with any dry start issues. If you can manage it, try pouring some down the lines to it, also.. but that may be overkill.


-justin
NO. you only fill up to the 'full' mark while the transmission is HOT and RUNNING. too much fluid can damage your trans just as quickly as too little fluid. be smart - there'* a reason they give you a procedure to follow.

and pre-oiling your filter isn't necessary at all. with the kind of pressure being exerted on the fluid, it'* not going to make any perceptable different to your engine whether or not you pre-oil it.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ddalder
General GM Chat
36
Jan 11, 2008 03:40 PM
J Wikoff
General GM Chat
14
Sep 22, 2006 03:53 PM
CSFiend
1992-1999
4
Aug 26, 2006 01:22 PM
zo6vette
1992-1999
3
Apr 17, 2005 03:07 AM
h1081dan
General GM Chat
20
Nov 7, 2003 10:58 AM


Thread Tools
Search this Thread

All times are GMT -4. The time now is 04:12 AM.