Hello,

I am in the process of installing a remote starter with keyless entry and a basic alarm. I the remote start function working, but there are some small wires I am having trouble locating for the keyless/alarm.

Specifically, I'm looking for:

Parking Lights: brown wire in lower driver'* kick panel
Trunk release: Orange, is this anywhere except by the release lever?
Tachometer: Purple/White somewhere

And it claims there is a light green factory alarm disarm connection, but it starts without it so I doubt it'* applicable.

Please be as specific as possible.. if there are pictures even better! Thanks!

for the alarm disarm did you lock the doors and wait about 30 seconds before trying to start it?

someone with a factory service manual can tell you

94 Pontiac Bonneville

12 Volts red + ignition harness
Starter yellow + ignition harness
Ignition pink + ignition harness
Second Ignition
Third Ignition
Accessory orange + ignition harness
Second Accessory
Data BusVATS ignition key cylinder (these 2 white wires are in a small orange srink tube, wires are very fragile, you must ohm out the chip in your key to find the resistance cut and then place the resistor towards the BCM sides)
Power Lock lt. blue + either kick panel
Power Unlock white + either kick panel
Parking Lights (+) brown low in drivers kick panel
Headlight yellow + headlight switch
Some models use white (-) at the headlight switch.
Door Trigger dk. blue or white - drivers door harness
Dome Supervision use door trigger
Trunk/Hatch Release black/white + low in drivers kick panel
Factory Alarm Disarm lt. green - drivers door harness (Must Be hooked up otherwise alarm will sound once the DOOR is open during remote start, sometimes alarm will sound during remote start)
Disarm No Unlock
Tachometer purple/white ac ignition coil
You may also use white at the back of the instrument cluster.
Speed Sense green/white 4
Located at the PCM in the passenger kick panel, or behind the instrument cluster.
Brake Wire white or lt. blue + brake pedal switch
Horn Trigger black - steering column
Wipers purple + steering column
Left Front Window (Up/Down) dk. blue - brown A drivers door motor
Right Front Window (Up/Down) blu/wht - tan A in drivers door or dkp
Right Rear Window (Up/Down) lt. grn - purple A in drivers door or dkp

I'm sure I'm probably looking right at them, but I'm just having trouble locating them.. just to verify,

The driver'* kickpanel is the area beneath the dash to the left, correct?

Is the door harness the harness directly inside of where the wires come in from the door?

Also, if I don't have a factory alarm, will I still need the disarm wire? It seems to be remote starting fine without it.

I haven't yet.. I'll give this a try

There is a whole built in passive system, thats the problem we had with my buddy'* GTO beacuse there was nowhere to hook up a factory disarm so the car would go to on mode then never crank

I just tried it, seemed to work fine unless I didn't wait long enough.

I would lock it, wait a minute or 2 then try it

if we remote started right after locking it would work but once the security system fully armed 30 seconds later it wouldn't work

Still seems to work fine. I had to put everything back together so I could drive it, so I settled with remote start and keyless entry for now. With that being said, for $90 I'm more than satisfied.

A Bypass module that "talks" on the data stream would fix your problems on that gto... his bville is to old for anything like that. If it doesn't honk or you can't find a disarm wire you don't have an alarm