Pulling motor!! What is the best way to do it??
Thread Starter
Junior Member
Posts like a V-Tak
Joined: Feb 2006
Posts: 25
Likes: 0
Originally Posted by lash
Originally Posted by skydog
Well Lowwer intake gaskets where shot!! Cleaned it all up and putting back togeather. 
Will take some pic and send to you!
Thank you !!!!!!!!!
Will take some pic and send to you!
Thank you !!!!!!!!!
Which gasket set did you use?
Gm gaskets, Looks like the UIM is new? Hey that big plastic tunnel deal that goes up in the bottom of the UIM can that go in both ways? Looks like it can.
Thank you Skydog
Senior Member
True Car Nut
Joined: Oct 2005
Posts: 7,030
Likes: 2
From: Central Florida
If you looked the LIM over carefully and saw no other reason, then yes, that would seem to be the reason for the oil.
Torque spec for Intake Manifold is 11 ft lbs (in sequence)
Here'* the TECHINFO article w/lots of torque specs:
Assembly Torque Specs for 87-99 Bonnevilles
Torque spec for Intake Manifold is 11 ft lbs (in sequence)
Here'* the TECHINFO article w/lots of torque specs:
Assembly Torque Specs for 87-99 Bonnevilles
Guest
Posts: n/a
Someone has been in that motor before... Notice the red silicone on the corners of the end seals... This is black from the factory... So these have been replaced in the past... 
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
Senior Member
True Car Nut
Joined: Oct 2005
Posts: 7,030
Likes: 2
From: Central Florida
Originally Posted by jr's3800
Someone has been in that motor before... Notice the red silicone on the corners of the end seals... This is black from the factory... So these have been replaced in the past...
Senior Member
True Car Nut
Joined: Jun 2004
Posts: 6,182
Likes: 0
From: Rochester, NY (college)
they look VERY good for gaskets out of a 96. I dont even want to bring out the pictures of my gaskets.
Something to note, almost every LIM that i have seen pictures of has had some oil in it. Levels depended upon the condition of the motor and the gaskets.
Something to note, almost every LIM that i have seen pictures of has had some oil in it. Levels depended upon the condition of the motor and the gaskets.
Thread Starter
Junior Member
Posts like a V-Tak
Joined: Feb 2006
Posts: 25
Likes: 0
Well all done, i should have done a compresion check frist i have a dead hole :(
Car started right up but running on 5cly. I pulled the vavle cover no bent push rods or any thing. My friend must have bent that rod from all the oil in the cyl? What you guys think?
Thank you Matt
Car started right up but running on 5cly. I pulled the vavle cover no bent push rods or any thing. My friend must have bent that rod from all the oil in the cyl? What you guys think?
Thank you Matt
Thread Starter
Junior Member
Posts like a V-Tak
Joined: Feb 2006
Posts: 25
Likes: 0
Going to go get a diffrant compresion gauge and check all 6 if the one in the front is the only bad one going to pull head. You guys think maybe a hung open vavle?
Thank you Skydog
Thank you Skydog
