New O2 sensor
#13
Guest
Posts: n/a
Maybe too young to drink?
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#14
Senior Member
True Car Nut
When I did my O2 sensor, I was too lazy to crawl under the car and I couldn't get a good bite on the sensor with an adjustable wrench due to the angle. I cut the single wire from the sensor, leaving enough so I could make a splice if I couldn't remove it, and used a deep well socket and ratchet from above. Very simple.
I think I'm going to be adding a crows foot socket to my tool box though as this is the removal method shown in the FSM.
I think I'm going to be adding a crows foot socket to my tool box though as this is the removal method shown in the FSM.
#15
Senior Member
Posts like a Camaro
Thread Starter
Join Date: Jul 2004
Location: Manassas, Virginia NOVA
Posts: 827
Likes: 0
Received 0 Likes
on
0 Posts
I dont know I dont have too much time and the free time that I do have I spend at the shooting range so I'll probably just throw some money away and take it to the dealer while I get my oil changed too.
#18
Senior Member
Posts like a Camaro
Thread Starter
Join Date: Jul 2004
Location: Manassas, Virginia NOVA
Posts: 827
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by willwren
Worst case scenario:
1. Spray it with penetrating oil. Drive it. Spray it again when you get home before it cools off completely. Spray it again an hour later.
2. Wait overnight.
3. Unplug it.
4. Unscrew it with a crescent wrench.
5. Get the neosporin and a bandaid.
6. Install the new sensor and plug it in.
7. Drink beer.
1. Spray it with penetrating oil. Drive it. Spray it again when you get home before it cools off completely. Spray it again an hour later.
2. Wait overnight.
3. Unplug it.
4. Unscrew it with a crescent wrench.
5. Get the neosporin and a bandaid.
6. Install the new sensor and plug it in.
7. Drink beer.