Harmonic balancer?
#1
Junior Member
Thread Starter
Join Date: Jul 2006
Location: ohio
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Harmonic balancer?
Hello, I have a 94 bonneville SSEi the harmonic balancer is bad, what kind of puller do you use to remove it.does it hook into the slots or to the 1/4-28 bolt holes behind the slots? Any hints or suggestions. the 1/4 bolt holes just dont seem like they would be strong enough. Thanks
#2
Senior Member
True Car Nut
Join Date: Feb 2003
Location: Philly
Posts: 4,508
Likes: 0
Received 0 Likes
on
0 Posts
#3
DINOSAURUS BOOSTUS
Expert Gearhead
Here'* the situation
They are M6x1. 1/4-28 is close
You'll need darn near a 2 inch bolt.. and the puller shaft that threads into the center will proabably be too short. Put something in the hole that will fill it and allow the puller to center. A socket inserted 6 or 12 points first will work well. I used a 3" extention or a piece of round metal rod stock would be perfect..but good luck looking around having it on hand.
They are M6x1. 1/4-28 is close
You'll need darn near a 2 inch bolt.. and the puller shaft that threads into the center will proabably be too short. Put something in the hole that will fill it and allow the puller to center. A socket inserted 6 or 12 points first will work well. I used a 3" extention or a piece of round metal rod stock would be perfect..but good luck looking around having it on hand.
#4
Junior Member
Thread Starter
Join Date: Jul 2006
Location: ohio
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
I got it off. Had to use a spacer as described in post. Looks like the compresser for the air conditioner is going to have to be replaced to. Thanks for the help!
Thread
Thread Starter
Forum
Replies
Last Post